Liczymy pasujące modele…
A holder for silica gel for Creality CFS. As I use it with a Creality K1 the original model does not fit on the smaller printing space, so I modified the model that it just have half the length. You need to print the model twice to get…
A cage to mount sumup solo / solo lite card readers at a fixed position and prevent it from getting stolen. 4x M3 heat inserts and M3 screws required for assembly. The cage can be screwed onto a fixed surface, using the screwholes on the…
The Atomstack P1 laser engraver has a ventilation outlet of around 50mm, while most air filters (like the Atomstack D2) need some 75mm tube. This adapter allows to easily attach these to the Atomstack P1. The 75 mm tube gets fixed using a…
A box for housing a potentiometer and connecting it to two banana plug sockets. Lid needs to be glued to the box.
An 3D printer holder for 2" optical filters like the NE2Rxx ND filters from thorlabs. Just put the filter into the holder and use the screw to tighten everything (slightly). If the filter has an SM2 thread, it will be exposed partly at…
An holder for active carbon filter fabric for the side air inlet of the Atomstack P1. This helps to prevent smoke entering your room and also scatters/blocks any laser reflections coming through the venting holes. Just cut some active…
Optical tables normally use a grid distance of 25mm. If you mount an additional optical breadboard onto the table, its possible that its grid is shifted exactly by half. This adapter helps to position optical components in half positions…
An blocking plug with an external SM1 thread. Can be screwed onto various thorlabs components and allows to block off beam pathes and close unneeded ports. Should be printed in PLA with a very hight resolution (0.1 or better) so that the…
A handle for door latch opener card. Just use a normal paper hole puncher to punch holes into the card and use the handle to make it easier to handle. For the handle you need to insert two M5x9.5mm heat inserts into the bottom part and…
I bought an cheap LTO-5 tape drive (Quantum HP 1-03516-02 AQ274F#900). It was however intended for use in an tape library and therefore has no door. To protect the tape slot from dust, I designed this door, that fits into the vertical…
GDR's Carl Zeiss Jena used a special non-standard thread of M19x0.75 for their infinite tubus length objectives. This adapter allows to use it in modern M27 threaded microscopes. Use PLA and a fine layer height of at least 0.1mm for…
MiniWhip Power Injector Case with 9V battery This is a case for the power injector delivered with my miniWhip active antenna. The Case has two holes to lead out the antenna and receiver connections via BNC sockets. Power for the antenna…
A replacement cover for a cheap potato peeler, after the original one was lost.
A simple box/shelf to hold a box of isopropyl wipers ( 103 x 55 x 50mm) on a honeycomb storage wall. Can also be used to hold other light stuff.
The intellical wavelength calibration light source is designed to be attached to directly to a spectrometer for calibration purposes. If you want to use the contained Hg and Ne lamps standalone, this adapter is useful to limit to exposure…
Allows to mount the remote of an Tomlov TriL110 to the back of the display unit. Just use double sided tape to mount it there.
Allows to mount the light module of an Tomlov TriL110 to the back of the display unit. Just use double sided tape to mount it there.
To wszystkie aktualnie dostępne wyniki.
