Liczymy pasujące modele…
Test Information I tested this hook using PLA+ at a 15% infill. I used a 20mm wood screw. 30lbs of resistance before breaking. Theoretically, using 4 or 6 supports (recommended) you could get up to 180lbs of bearing weight. Print at a 50%…
For strength print with a 30 - 50% infill. Width & length = 100mm, Height = 25mm. Enjoy!
The edge version will need supports only for the round guiding hole, but that's it.
I could not break this, no matter how hard I tried. Tested as a shelf support with added weight (50lbs) How It Works: This corner bracket is engineered around one of the strongest shapes in structural design: the triangle. By reinforcing…
Version Two Changes: This new design offers way more resistance, strength, reliability, and sleekness. The screw holes are designed for any Philips beveled head screw. Printing Recommendations: I recommend printing this with no supports…
This is a plant watering system I made. This system has quite a few parts, so listen up: The slider slides into the “MidLeft4Drip” The Midleft4Drip attaches into the “Bottom4Drip”. The “MidRight4Drip” attaches into the Bottom4Drip. You…
This is a mount for a Scarlett Solo 4th Gen (audio interface). I probably made about 5 prototypes, but this one finally fit perfectly . It took about 3 hours and 30 minutes to print (Old version) using PLA+. Screws are needed, for mine I…
Dimensions Plant base: 75mm x 75mm x 80mm Nex (planter): 100mm x 100mm x 100mm Enjoy!
To wszystkie aktualnie dostępne wyniki.
