Liczymy pasujące modele…
This part can be used with aftermarket steering wheel bosses that lack or have poor engagement with the turn signal switch. There are intentionally no holes on this part so that you can print it and drill your own or use epoxy. I used…
This gasket/shield fits around the blue collar of the KAD short shifter for a classic Mini and is installed between the gaiter/gaiter ring assembly and the floor. I intentionally left off holes so you can make your own to fit your…
This is a tool for tapping in the outer race for Classic Mini rear taper bearings. This should be printed with a fairly high infill.
This insert will let you snug down a knob on the KAD short shifter and clock/align it appropriately. In this case, I'm using a Retro Components knob with the Classic Mini 4-speed shift pattern. Tightening it down without this insert…
This plate will hold an SU carburetor needle in a repeatable position so that you can mark the stations for polishing/modification. The needles vary in length, so yours may not go to the bottom of the plate and the number of stations used…
Keep your sunglasses close by in your Classic Mini. This model uses the center mounting bolt to attach to the seat bracket. There are two versions available - one with the hole on the left and another with the hole on the right.
To wszystkie aktualnie dostępne wyniki.
