Liczymy pasujące modele…
A minimum impact approach to adding 30mm stack support to an already fantastic drone. What you'll see on mine in addition to the changes made to the model were to accommodate my specific hardware. - Drilled all 4 front camera mounts out…
I made a flange for mounting this light blocker to a tent wall or to a hard box. If you are using this on a tent put it where you want it, poke holes for the screws, screw the inner and outer flanges together with the tent. Then with a…
Mounting case for matek optical flow and lidar sensor with 30x3mm bolt pattern. Fits GEPRC GEP-LC75-V3 or any 30mm mount. These things are made to pretty shoddy tolerances so I provided the files if you need to nudge the loft for the…
Has a 3mm ledge inside to further protect the lens in the event you really mash it into something. Does not interfere with the focus lock ring so you wont accidentally mess with your lens focus.
There are a few iterations of this but they many of them use weaker magnets and just rest on top of the corner screw heads. This allows the top panel to vibrate and creates a poor seal if you're trying to keep it heated. This design uses…
Best printed out of TPU. I print it with 0% infill and 3 shells. Light, flexible, sturdy “enough”. You don't want something to resist a PVC gate at 50mph. It just disintegrates.
I've printed them on their sides, with and without supports and the only way that needs supports is flat down as shown. The back still prints fine though. The only recommendation is extra perimeters and a decent infill ratio. If they are…
To wszystkie aktualnie dostępne wyniki.
