Liczymy pasujące modele…
A SKADIS holder for a standard lighter. I made it because I use a lighter to get rid of stringing on my prints but it always gets lft on the desk so I made a holder to fit it on my SKADIS.
This is a replacemnt for a goosehill padelboard skeg. This is the clip that holds it in place and broke for me so I made a replacement. I would recomend making out of ASA if possible but if not use PTEG.
This phone stand, named BedFlix, is a stand for a phone that has a built in componsating for the annoying bit of duvet that always gets in the way while watching in bed. This was designed wiht am Iphone but will wokr with pretty much any…
This is a SKADIS mount for holding a SolderWick. I made this to go with my other SKADIS builds.
A way of attaching a standard coffe cup to a scaffolding pole. It is moddls of off a standard 1.5 inch pole and to fit a standard costa coffee cup. It holds well as can be seen in the pictures.
This is made to replace the rudder on my TigerShark rc boat. You would need to cut the bottom of the rudder off, just above the bearing housing. Then using epoxy and a few nuts and bolts attach the bottom ahlf to the rest of the rudder…
A lower suspention strut for a tamiya lunchbox/midnight pumpkin. I broke the plastic part doing some tricks and I have made a new one. I suggest making it out of PETG or ABS/ASA.
This is another small ship that I have designed for a race that I do with my family. This is the standard design fro the ship which is normaly made of wood but I have made so it can be printed.
a blade guide replacement for my bansaw. It is 40x40mm wth a 3m radius on the corners.
To wszystkie aktualnie dostępne wyniki.
