Liczymy pasujące modele…
I love this model!! Thank you for McGybeer for sharing it! I have printed several hundred of these to donate to Toys for Tots, and thank you again to McGybeer for allowing us to! There is just one small issue with the spiral version,…
This remix builds on an existing great design, but just scales it up to fit larger 12"/30cm spools, commonly used for 2.3kg, 2.5kg, or 5lb spools. I have primarily used it with spools from IC3D and Printed Solid, which are roughly 4.25"…
The original switch bracket hits a rib on the back of the machine, and makes the switch deflect upwards. It was causing inconsistent triggering of the switch. I add a recess on the back of the bracket, so it would mount flat on the back…
This replaces the original shroud on the Comgrow Z1, and is the same height as the one used for 10 watt Z1. The top plate mounts with the same screws that hold the original shroud, and the nozzle section attaches with 6x2mm magnets. This…
This started as an experiment to see what I could do with an old motor from a hard drive. I had a bunch of loose motors left over from harvesting the magnets from them. So I picked one of the motors that seemed to be the fastest, and…
I love using the original Under Shelf Rewinder from INeedOneDesigns, and my own subsequent remix for larger 2.5kg spools . However loose filament coils, such as samples, have a tendency to jump off the sides of the rewinder spool, and…
To wszystkie aktualnie dostępne wyniki.
