Liczymy pasujące modele…
Place screw heads in the channel at the top and let them roll down to sort into the baskets. The whole screw sorter is split into a top and bottom piece that go together. The top screw sorter sorts short screws from .375" to .875". The…
5:1 gear ratio gear box for demonstration. Gears are aligned in the middle with spacers and the shafts and handles are held in place by c-clips that act as shaft collars. The c-clips can be hard to snap on but you can just slide them on…
Works for pipettes that have a hook on the end. Can hold up to 6 and can rotate by twisting the knob at the top. All parts can be printed with no supports at 15% infill. Parts fit together with square connectors, make sure they are…
T4 phage with 5 parts printed separately: capsid, base plate + sheath, collar, spike, and tail fibers. The sheath fits through the collar and into the capsid. The spike and 6 tail fibers fit into the base plate. The capsid can be printed…
2 sizes: 96 well and 120 well. Arranged in rows of 8 spaced 9mm apart to allow for multi-channel pipetting with some common brands of pipettes. Bottom of each well tapers to a point to help tubes sit upright. Both sizes are available with…
There is a version with and without handles. Holds 48 0.2ml tubes, 40 0.5ml tubes, and 36 1.5/2ml tubes. The bottom of each well tapers to a point to help tubes sit upright. The 0.2ml tubes are arranged in rows of 8 spaced 9mm apart to…
3 sizes: 40 well, 60 well, and 80 well. Bottom of each well tapers to a point to help tubes sit upright. All sizes are available with and without handles. Print with 15% infill and supports if printing handles. Dimensions (mm): 80 well:…
T7 phage with three parts printed separately: capsid, tail, and tail fibers. Tail fits into the capsid and 6 tail fibers fit into the tail. The capsid and tail fibers can be printed at 5% infill with no bed adhesion or supports. I…
The adapter is the same width as 1.5ml and 2ml eppendorf tubes and is designed to hold 0.2ml pcr tubes for use in a microcentrifuge. The hole has a diameter of 7mm. The diameter is about 10mm throughout the bottom and about 13mm at the…
Printed in parts that can be put together with printable screws or dowels. Dowel 2 can be used for less wiggle room. The side can be printed in two parts and put together for smaller beds. There are versions of the top from 6 to 10 inches…
Lambda phage with 4 parts printed separately: capsid, tail, central tail fiber, and side tail fibers. The tail fits into the capsid. The central tail fiber and 4 side tail fibers fit into the bottom of the tail. Everything can be printed…
There is a small and large size that may fit different pipettes better. The holders are made to be attached with duct tape as shown in the picture. I printed as is with 15% infill and supports underneath, but other print orientations may…
To wszystkie aktualnie dostępne wyniki.
