12 modeli
This is a remixed model with specific changes to fit a Noctua NF-A4x10, Though the changes should result in wider compatibility with other fans as well. Note that this bracket, and the original it is remixed from, is compatible with the…
This is a simple stand for storage or display of Paintball Loaders / Hoppers. It simulates a feedneck and is oriented in such a way that it balances most modern rear heavy loaders over the center of the stand. The feedneck in the stand is…
A Remix of @mhparsons five can beverage holder that has been widened for 19.2 oz cans. I don't see any strength issues with the wider design so far, will be monitoring for issues. This wider size is 8.17 inches wide x 13.16 inches deep x…
Added a countersink hole to the bottom so that you can use the cover as a wall mount. Also made a variation that has an angled base so that you can have gravity help keep the battery in place.
This is a 4x3x6 Gridfinity bin designed to hold a Klein VDV226-110 Ethernet multi-tool. It is designed to hold the crimper in the almost-closed position to reduce the size of bin needed, set the crimper to the very last ratchet notch…
I had some trouble with the original plug design, if you're not careful you can push the plug too far in and then you need to get a tool to try and depress the disconnector ring on the bowden fitting. This is meant to remedy that by…
Fairly simple duct that sits on the sill of my garage door and lets me attach a 4-inch hos for ventilation. Prints without supports if you lay it vent side down. Holes are countersunk for #8 wood screws.
This is an adapter designed for a Vacmaster AM201/AM201R air mover to attach a 4 inch duct hose to one side of it. Version 1 (Deprecated) uses the existing pegs on the left side of the unit to attach, the current size is a loose fit.…
I designed and tested these a while ago. There is a GTX version, tested with GTX 900 an GTX 1000 series GPUs. But should also fit GTX 700 series. And an RTX version that has been tested to fit with RTX 2000 series GPUs. RTX 3000, RTX…
This is a 5x1x3 bin for holding an RCBS Accessory Handle 2, or RCBS brush handle. It is meant to hold the handle with either the nylon brush attached, or with the primer pocket brush attached. This Gridfinity bin was designed with the…
This is a 5x4x4 Gridfinity bin meant for a Rack Solutions brand 'World's Best Cage Nut Tool'. Having used it, I can concur it is the Worlds best Cage Nut Tool. The tool is seated deep enough that other bins can be stacked on top. This…
This is a 4x4x5 Gridfinity bin for a Zip Tie Gun that I bought a few years ago on Amazon. There are a few rebranded versions available, they look like this:…
To wszystkie aktualnie dostępne wyniki.
