Liczymy pasujące modele…
hello everyone , before all, Iam new in 3D .. and I seen lot off presses here and seem to me to much complicated, prints with suports etc .. I did try to make siply almost no support easy machine . I used screws M5 hex head and mother ,…
YES, again next Filament Respooler , BUT…. like always, I dont like complicated things, i used an idea from others , but i did printable almost without suports. and also more stronger. My print from others was weak, lot of suports and lot…
travel clothing hanger , with turninng hook and hole for next piece. two different width, 37 and 45cm used PLA with 15% inf.
travel clothing hanger 2.0 , with turninng hook, small gaps for henging woman accessoris and hole for next piece. width 45cm 3 perimeters, 15% infil
printed out from PETG , 20% , 3 perimeters.
Plumbing Wall Faucet Mounting and Leveling Jig are simple tool for preparing your kitchen- bathroom plumbing between 100 and 150mm . Leveling easy and always exackt . can be used as jig for faucets , example in shower or also with HT…
simple thing for help chill RC car springs and tires , I printed from PLA , 15 % infil ,2 perimeters without suport. this stand ist from 5 cm to 6,5 cm higness . I also used nail as pin . If you need bigger , just make bigger in slicer..…
print and click togheder. i didnt use glue ,but you can
trochu masíčka pro dětskou kuchyň , material PLA , 15% infil , 2 perimetry. velikost je .. zvolte si ji samy v sliceru
like i said before few weeks I started modeling RC car , hot rod or rat rod if you like, and still experimenting with rims for it . maybe you will like also material its PETG and 25% infil … but you can use any material and seting how you…
front weel , rim for RC … 4mm shaft . ballberings are used 642z (14x4x5). glued from 4 pieces, why? cause print go without support .
1:6 scale tracks for halftrucks sdkfz 10 or 250 or 252 I printed this from PETG , 0,15 leyer , 3 perimeters rubber piece are from TPU
cause iam in weelchair, and jumping over door make me bad feeling, i created this ramp. with pla ,15%infil and 3 perimeters + 3 layers , are strong enought for holding 130kg . and of course easy going over door .
front weel , rim for RC … 4mm shaft . ballberings are used 642z (14x4x5). rear set are here : https://www.printables.com/model/1438266-rc-car-rim-12hex
1:10 scale tracks for halftrucks sdkfz 10 or 250 or 252 I printed this from PETG , 0,10 leyer , 3 perimeters rubber piece are from TPU
To wszystkie aktualnie dostępne wyniki.
