Liczymy pasujące modele…
Check out the new version! Like the magnetic version, very easy to assemble, just print and put together. I would say the main difference is the lack of the satisfying snap from the magnets and the extra step to lock/unlock, but I think…
Compatible with the magnetic, twist lock and one button articulated arms. *Added longer jaws for tablets or smartphones in landscape in a remix* *Removed the remix and included longer jaws here for tidiness *Added an alternative holder…
Already compatible with the accessories designed for the previous arms. Some I already included within this page, these are also available Smartphone/tablet holder: Swivel clamps/base: Helping hands adapter: This articulated arm is…
-Added a version with a 5.5mm deeper filter compartment in order to add active carbon filters -Added seals holder -Added two 'less supports' versions with the middle strip removed, the filters are supported by a thicker lip. Many thanks…
To be printed in soft material like TPU, it's 0,4mm thick, you can print two layers 0,2mm each. Works well just printed after the muffler and applied on top, like I did. If you haven't printed the muffler yet I'm also including a gasket…
Measure the thickness of the surface you want to put the clamp on, and choose accordingly. I designed them this way to prevent the excessive flex one-size-fits-all clamps have, especially on thinner surfaces. The screw thread is about…
Replacement for the 'clip part' of the 8bitdo smartphone clip that attaches to a Black Shark Cooler 5 Pro. Enable supports, I suggest printing in the orientation the .stl file is saved in to improve "structural integrity".
All the weld dimensions are precise except 20 and 35, which are a little off (20,36 and 34,19). Watch out for temperatures.. either wait for the weld to cool off, or use a temperature resistant filament. I have one printed with PAHT-CF…
There's some bridging but supports shouldn't be necessary, if you can print a decent benchy, you can print this without them
Should be printed in TPU, default settings are fine, just needs a support for the connector piece in the middle.
Print this in TPU, I also suggest printing the keychain part at a 45° angle with normal support, like in the picture.
This organiser was designed to maximize drawer space and be as large as possible while fitting on a 256x256 print bed. All the components can be printed simultaneusly on a single bed without supports.
Bottle neck and cap are made with Steve DeGroof parametric cap/lid https://www.printables.com/model/216019-parametric-bottle-cap-jar-lid While the cap of the ‘big’ chamber is screwed on and the one of the small dosing chamber isn't,…
To wszystkie aktualnie dostępne wyniki.
