Liczymy pasujące modele…
Minimalistic replacement for the tiny piece of plastic that holds each earcup of Audio Technica ATH-M50X headphones in place. Note: it's more rigid than the original solution, so headphones are not going to fold as nicely anymore. What…
Small stand that holds a single greeting card, postcard, birthday card, or any other typically sized card, without toppling over. Can be resized to accommodate various widths.
Provides extra protection for clip-on sunglasses. Internal dimensions: 162mm x 55mm x 9mm. Works well with an insert made of this pouch, though the fit may be a bit tight: https://www.amazon.co.uk/gp/product/B078ZW4GTX/
A box for storing a VIFLY WhoopStore 1s LiPo charger (https://www.viflydrone.com/whoopstor.html) together with a short cable (the included USB-C cable or similar). The lid comes in two versions, with and without text ("VIFLY WhoopStor")…
Holds up to three remotes stacked on top of each other. Original dimensions are H85mm W74mm L80mm but length can be easily scaled to accommodate shorter or longer remotes. Printing in PLA with a single perimeter and 15% gyroid infill…
A small rubbish bin / trash can for leftover filament fragments and failed prints. By default 120mm (height) x 120mm (width) x 54mm (depth). Most likely can be used for anything else that's better placed in a semi-open container of sorts.
Holder for various vertical things. Designed to accommodate typical shavers / hair trimmers. Internal dimensions of each section are 50 mm x 48 mm x 110 mm (W x D x H). But they're angled and slightly tapered to the bottom, so that…
A small slide / chute with raised edges and a back wall to avoid water spillage. Originally used to redirect a tiny leak. Printing vertically should lead to a smoother surface. This is a deeper version of:…
A small slide / chute with raised edges. Originally used to redirect a tiny leak.
A hanger that can be inserted into acoustic foam (tested only on 3cm to 10cm thick Basotect) and hanged on a screw placed in the wall. I used 3mm flat-head countersunk screws. It comes in two versions, depending on the thickness of the…
Designed for Hercules 5-guitar (HCGS-525B ) and 3-guitar (HCGS-523B ) stands. The goal was to add a couple of centimetres, so a robot vacuum can easily pass below. Recommended high infill percentage with a sensible fill pattern. Here I…
To wszystkie aktualnie dostępne wyniki.
