Liczymy pasujące modele…
This is a mount which offers a couple of ways of securely holding the SBF405 Wing. I don't like attaching flight controllers to airplanes with just velcro/hook and loop because they are never securely held in place and the FC can sense…
Simple clamp for ¾" conduit
50mm x 35mm pill case with three compartments and screw-on lid. Printed in PLA with no supports needed. The space at the top is for a bit of cotton wool to absorb moisture. “Bottle 2” has a higher internal divider.
Holds 2 large glasses or up to 4 liqueur glasses securely, in the dishwasher. Printed out of ABS. Swivels upward when not in use. Slips over 3 tines of the drawer so it holds well but is easily removable. The tines are 39mm apart. I…
75mm diameter pillbox for travel, camping, personal use. Print using food-safe PLA etc. Note that the image is of my smaller case: https://www.printables.com/model/524384-3-compartment-travelcamping-pill-case
I needed a bench power supply and some research turned up the excellent Riden RK6006 and RK6006-BT (bluetooth). Found a new old-stock blower-fan in my stash and built an enclosure around the RK6006, the blower fan, banana jacks, dc-dc…
Clamp for holding 2 x 22mm Teck cables or whatever fits
This is a replacement door for the Volantex Trainstar Ascent. The door is made to be very thin and light. If printed curved-side-down it should require no supports. You will need to use magnets or a pivoting catch to hold the rear.
Better dust extraction for the Makita DXT saw; these prints allow you to use two 32mmOD/28mmID hoses connected to a ShopVac. The elbow must be glued together (easier to print). The Hose to saw adapter is designed to be tight so you may…
Grommet for passing wires through walls. No support etc.
Jig for drilling dowels in edge and surfaces for cabinet/box making No supports needed. Edge guides snap in for centering. (I ran out of white filament :) )
Winglets for the FT Spear - Wing tips, with blister for internal LED. Winglets are not interchangeable - there is a left and a right. Blister is, so print two.
This is a hold down and an aligner for holding foamboard or depron sheets in position when using the TimSav needle cutter. Made to use M4 screws or any screw smaller than 4mm.
Motor-mount holes are 30mm square. The other two holes are to allow bolts to pass through the aft fuselage, which you can then secure with nuts, inside. Category: R/C Vehicles
To wszystkie aktualnie dostępne wyniki.
