Liczymy pasujące modele…
I used the moai candle mold from the source, increased the size to get a proper candle and reduced the amount of plastic around the model. Now it uses way less plastic and prints faster. Print it laying down as in the title image.
A remix to combine both models into a single one. Print with supports!
A insert to use crystal bottles with the sodastream duo. I added a hole to easily remove the adapter when you want to use other bottles. + I removed the sharp edge.
Since I did not like the original mount for the high beam button, I created one where the button sits on top of the bar. Suitable for 22mm bars. Use a M3 screw to tighten the mount to the bar. Enjoy.
A bike disk brake shield. Use: To shield the disk brake from lubricant mist when using spray to lubricate bicycle chain/ drivetrain. Print the model two times and losely connect one end with a zip tie to keep it rotatable. Outer diameter:…
With this remix you can use your Ender 2030 endstop switch as a filament runout sensor. I added the possibility to use two pneumatic fittings to have a stable connection. Put two M6 nuts inside the fitting holes and screw in the M6…
I created the model to have a way cheaper mount than the original one and tighten the frontlight position from 2 sides to keep it from tilting on hits to the bike. Print 2 parts: Part 1 → 2 variations: one for a M5 heat insert, one for a…
Since the original model always broke when putting it on the lamp I remixed it. Increased size to 102% to prevent breaking while putting the shade on the lamp doubled the wall size added screws for the diffusor as a design element → use…
A simple Nintendo Switch cartridge case to hold 16 cartridges.
A sturdy wall mount for a hand vacuum. Suitable for the Fakir AS 1037. Mounting holes are 53mm apart, since this was the size of the previous wallmount. I used 168gr of PETG to print this.
Use a curtain rod or something similar as clothes rail. I use it to convert 2 kallax into a wardrobe. Suitable for max. 30mm rods. 1 model to hold the rod if necessary. 1 model to lay the rod on it and keep it in place.
A patio door handle for a friend of mine. One part is for heat inserts. The other one for screws.
toggle switch dimensions: 12.5mm x 11.7mm hole diameter: 20 mm outer 4 screw diameter: 4.5mm holes for M4 screws
A thin card to separate things (e.g. cards) in your wallet from each other. V1 It is a bit wider than a standard credit card and several mm larger. V2 is as wide as a standard credit card and some mm larger.
To wszystkie aktualnie dostępne wyniki.
