Liczymy pasujące modele…
Neck shims for a Precision bass in 3 different angles: 0.5 - 0.75 and 1.00 degrees. to change the angle of the neck and to lower the action (height) of the strings. worked fine for for me printed in carbon fiber PETG with 100% infill and…
Replacement Axl for Playmobil Roman chariot. I've made 4 different sizes because I noticed with different filament and printers, the fit was a little to loose or to tight.
A simple case for TL-smoothers with a board size of 50x28x8. there is a single version and a double version with some mounting holes
a Raspberry Pi4 "heatsink" case is smaller than most cases, and existing Mk2/Mk3 mounts were a bit to large. so I've made this smaller one. If you add a little strip of rubber foam in the bottom it will be a tight fit
Simple spicerack for jars up to 46mm, for mounting on the inside of my kitchen cabinets (but you can scale in your slicer if you want make it a little wider off course)
The outdoor thermomete of my weatherstation is not 100% waterproof. So I designed one with slats for good air circulation and shade for accurate measurements. Lid with glued-in magnets 5mm. I used a melt-in insert for the screw on which I…
small rope cleat 120mm and 90mm. Print on its side without supports, 100% infill. For use with thin ropes of 3-5mm
I stored my filament on shelves in an Ikea Billy. They move al the time from storage shelves to the shelves with my dry boxes, so I made labels that can move along, so I always can see what is where. You can put a piece of filament in the…
The outer sheathing of my 3DConnection Space Mouse cable (first edition?) started to tear. So I designed a cable-routing stand/sleeve to prevent further damage. It fits over the existing stand and has a slightly less sharp edge. It's…
To wszystkie aktualnie dostępne wyniki.
