Liczymy pasujące modele…
you will need to shorten ptfe from extruder to hubs by 9mm this prevents the jamming of lane 4 by adding length to allow internal geometry to better direct the filament and keep it from hitting the wall where the bearing for the filament…
kept having to dig for this to share it out and it was locked behind a VOC channel. created by user Thor. Original WWG2 can be found here https://github.com/tetsu97/WristWatch-G2-Extruder/tree/main
Doom Micron mods by Doom Discord community https://github.com/DarthPope0327/DooMicron Base build parts should be gotten from the printers for ants github. https://github.com/PrintersForAnts/Micron These parts are for modifications to turn…
added a hole on the depressor for a 6x3 magnet and a hole for a m4 grub screw on the cutter arm to assist with returning arm to normal position after cutting filament as sometimes the spring is not enough to return the arm.
This tip can be used with the scrap foam from cutting down MXL to 70mm for use with the mammoth greg. NOT INTENDED FOR USE AGAINST ANYTHING LIVING!!!!
mount for fan splitter pcb. holes sized so heatsets can be inserted for mounting using vhb or used as a spacer to keep it from shorting when mounted to 2020 extrusions. V2 has holes spaced further for better alignment and a solid bottom…
Move the x end stop to the gantry cause no end stop mount on Jabberwocky.
painted version of the faceplate
x endstop mount. bolts above rear fan duct. requires 5mm longer screws. Print in high temp materials
This one is less likely to bend and pull the wire out of the o2s board and also allows for use of wire sleeving and wire for supporting the umbilical due to the fact that it uses zip ties rather than a printed part to secure wire to…
To wszystkie aktualnie dostępne wyniki.
