Liczymy pasujące modele…
This Blitzball is mainly used for pitching as it can survive impacts to the ground, but be careful when using it for batting as the ball could explode if hit hard enough (Personal Experience). The ball moves in the air like a regular…
Print Settings I used to make it as close to the real weight as possible: Setting Value Infill Gyroid Infill % 10% Walls 2 walls Top Layers 3 Bottom Layers 3 Layer Height 0.20 mm Top/Bottom Pattern Concentric Nozzle 0.4 mm Material PLA
Takes about 4 hours to print in .25mm. No supports and print in place.
The full size is now 3inx3inx3in Print Settings: Layers 0.20 mm layer height Walls 3 walls (≈1.26 mm) • 6 top / 6 bottom Infill Gyroid • 10% (adjust 9–11%) PLA Temps 205–215 °C nozzle • 55–60 °C bed
I made 3 different-sized caps for these sized pipes: 1/2in, 3/4in, and 1in They fit onto the pipes really well and are decently tight, but these are not waterproof unless you use PVC pipe glue. Very strong and doesn't cost much filament…
This holder is very durable and can hold the heaviest towels, weighing up to 7 pounds. It takes approximately 30 minutes to print at a thickness of 0.25mm. There are no supports needed, and it is printed in place for easy installation.
To wszystkie aktualnie dostępne wyniki.
