Liczymy pasujące modele…
Adapter for Wera wisselklingset 9mm to regular hexbit. This way you can use standard hexbits in your toolset. Fit is thight, no detent or interlocking parts
A model in 3 parts. It's not to lifesize, but can be shrunk to the size you want in your slicer.
Just a simple badgeholder for mounting against the windscreen, after you've left the original one in your last car and sold it. Takes about 20-25 min. to print
Little dollhouse picknicktable. It's a difficult print, but very rewarding when ready. Best used is treesupport and the table on a 45degree angle.
Replacement part for the hinge between cover and pullbar. This is for the DWST83347-1 This is a weak construction from DeWalt, which broke on mine. Therefore this replacement, which is much stronger. You need to remove the old (broken)…
Replacement part for the hinge between cover and pullbar. This is for the DWST83347-1 This is a weak construction from DeWalt, which broke on mine. Therefore this replacement, which is much stronger. You need to remove the old (broken)…
Just a model of the wellknown german handgrenade. No inside details, great for cosplay or warreenactment
Knifeholder for the Ikea Cuttlerydrawer. This insert can be used to stash your knife in an orderly way
It is about 15x15 cm. It's stackable, so items can be stored in them
Beltclip with basic toolplate. You can attach tools or bags to this clip and easely de- and reattach it to your belt. I printed it in PETG for strength, but PLA will do, better is ABS. Total printtime was about 16h, infill 50%
Wallhanger for cheap amazon roomsensor. Printed in 1,5 hour on ender 3 V2 layerheight 0.2 gungrey filament
Lampholder for (non-)electric recumbent trikes. Clamps on top of the front pole, where the gearchanger is attached. This way the lamp is higher up and gives a better lightfield.
A small 25mm magnetic pin or paperholder. Easy printable, takes about 6 minutes on a bambu lab P1P, but won't take much longer on any other. You have to pause the printer at the end of the last layer, before closing the print. At this…
Nozzleholder for 3 complete nozzles en 3 spare ones. It is equipped with indicators for nozzlesize en hardened or not. Indicators are made from 1.75mm filament and so can be cut to preferred size. The extra storage can be used for…
Latch to keep open your dishwasher. Needs to been mounted on the right side of the dishwasher. When not in use, it locks away above the dishwasher. When in use, it locks in an over 90 degree angle, so you can rest your dishwasherdoor…
To wszystkie aktualnie dostępne wyniki.
