Liczymy pasujące modele…
Suitable for volvo xc90. I have installed the one to my car in place of broken LH 1882 & RH 1882 part. On the picture is the draft part to check the suitability on place. I'll print the proper color later.
On pictures installed to 2016 XC70 volvo.
Close similar box with two latches on the shelf.
Nato rail attachment for Colt M1911A1 pistol. Made for airsoft gun so for real gun the shell outlet may be an issue, but in airsoft gun works properly.
Boat Ø25mm handrail cup holder attached with L35mm M6 bolts. I recommend to use A4 quality. Dimensions made for standard 0,5l beer can as in picture.
Shoe dryer for 80mm computer fan
9l reflex case for 8" HELIX Sub Helix_IK_W8-SVC2 BOM Table ITEM NO. PART NUMBER Product_description Product_description2 QTY. 1 VOLVO_XC90_R_SID E_2 Trunk right side subwoofer case For 8" Subwoofer 9l reflex case 1 2 Helix_IK_W8-SVC2 8″…
Rear speaker installation set for 1" tweeter and 6,5" woofer for volvo rear door. On the pictures are 1st gen of the model, but on thje second gen of the desing is the cable attachment holes and less material consumption. Woofer…
Light fixture to replace broken one. Use good quality print material for component. 1.insert M3 thread insert to original place. 2. test with printed part that fits to place. 3. glue the part to place. 4 install light to place.
Boat handrail pipe Ø25mm cup holder attached with L35mm M6 bolts. I recommend to use A4 quality. Dimensions made for standard 0,5l beer can as in picture.
Children play soup pot and cover
Audi A6 allroad level detection rod support for 2013 year air suspension. Don't know if this works on other models also. With this fixed broken rod without need of change of component.
Boat rod holder to D25mm handrail and for four rods
15" subwoofer cover made wiht 4 sections. On center is attachment part which is screwed together with M3 bolts and brass inserts.
Genelec wall mount. Note strength not calculated, but with proper material should work. The model is made to old 8030 base attachment and cables can be led though pipe design.
Small box to store equipment. Box has locking system and lid.
Assemby of computer fan to make intake vent from 120mm computer fan. Note you need power supply and fan for project, but this works. :) Low voice and good venting compared traditional units. Closable lid enables also full closing by…
I made the model to cloth closet wire box which had problem of all the time removing rail. Now the rail stays on place on this attachment and M4 bolt attached to it. On the pictures the grey part is the old and the orange is the new one…
The model is holder for handrail for bow electric motor with Ø30mm tube and to Ø25mm handrail. I will update the pictures when installed to boat. The bolts for use are M3 and M6. I used for quick attacment M3 brass inserts to have bolts…
Keep your room chilled and ventilated. Fan housing to install closable wall valve for venting by using 120mm computer fan. Decor biohazard and for middle i planned to use PLA Glow filament to make nice Biohazard glow affect to unit and…
Polaris Outlaw 90cm³ light attachment to replace orginal lights. The year of the ATV is 2007 and i don't know how well it is suitable for other generations. This replaced orginal lights with…
To wszystkie aktualnie dostępne wyniki.
