P
PrintablesRefnal01
Anycubic I3 Mega Anti Vibration Feet
Print in PETG for optimal results, but PLA will work too. Print 4 of them and just put them under the original feet.
- Pobrania
- 230
- Polubienia
- 20
- Ocena
- 5
Wszystkie modele
Liczymy pasujące modele…
P
PrintablesRefnal01
Yubikey 5 Series USB A/USB C Cover
Print standing up like shown in the CAD picture. Support only under the “Bridge” between top and bottom half. Print in TPU, i used Extrudr TPU medium so it doesnt need to be extremely flexible.
- Pobrania
- 81
- Polubienia
- 12
- Ocena
- 5
P
PrintablesRefnal01
KTM 990 Adv Brake Cylinder Cover
Cover for protection of the rear brake master cylinder. Print it with 100% density atleast in PETG, better ASA or PA
- Pobrania
- 81
- Polubienia
- 12
- Ocena
- 0
P
PrintablesRefnal01
Motorcycle licens plate holder (Quick Change)
You need a variety of M6 srews, washers and nuts to mount this on your bike. Lenght may vary depending on your Bike. The washer in the middle, which the magnet attaches to needs to be countersunk. I also recommend reinforcing your plate…
- Pobrania
- 52
- Polubienia
- 0
- Ocena
- 0
P
PrintablesRefnal01
KTM Lc4 Ventileinstellwerkzeug/ Valve adjustment tool
Das Modell MUSS auf dem dünnen Ende stehend gedruckt werden, da ein 1,0x5,5 Schlitz-Bit eingedruckt wird, ansonsten lässt sich dieser nicht einsetzen. Der Druck sollte dazu an der passenden Stelle (bevor das vorgesehene Loch überbrückt…
- Pobrania
- 40
- Polubienia
- 7
- Ocena
- 0
P
PrintablesRefnal01
Sodastream Grippy Bottlecap Sleeve
Grandma was having trouble to open the slippery Bottlecaps, so i made these sleeves that simply push onto the original Bottlecaps. No Glue needed. I printed in Extrudr Medium TPU but other TPU's should be fine too.
- Pobrania
- 20
- Polubienia
- 2
- Ocena
- 0
To wszystkie aktualnie dostępne wyniki.