Liczymy pasujące modele…
This is my custom-made support for VKB Gladiator NXT. It uses some M6 screws and a simple clamp to fix the support to the desk. There are 2 types of alignment parts: The straight one, to ensure the support is perpendicular to the desk The…
Mainly designed to allow Bambu to use single spool or AMS without disconnecting tubes. It is a simple design, without any adapter needed, just some serflex… Made for original bambu PTFE tubes, which have a 4mm diameter outside and a wall…
If you own a Serpent X20, you know that measuring the real caster angle could be challenging. Setup sheets are talking about shims but never about the real effective angle. I've designed these part to be mount on a Hudy setup system…
This allows to mount a low profile servo horizontally on the chassis. It has been designed for HighestRc servo. Please check if your servo has the same offset.
The Durango DEX410 V3-4 RC buggy is an iconic car, designed around the utilisation of two saddle packs installed in the rear of the car. Even if the car is quite old, some fans are still using it, but saddle packs are now very hard to…
When you are building a touring car rc kit, there is always a step about building the turnbuckles. There are a lot of ways to assemble them, with a variety of existing tools on the markets. This tool has been created to make twice faster,…
Small closet with three drawers racks. Half-height drawers with pins are also included.
The latest revision of the airtube to mount a 40mm fan on a Serpent X20. It creates a 2mm gap around the motor, creating a air flux and allowing to pass the ESC cable above the motor and getting it back just beside the receiver. Print…
A lowered version of motor mount for MST TCR rc car
Despite its beautiful design, the front bumper is not touching the bulkhead, so a bad crash and everything's gone :-(
I recommend using a PETG-CF to print these part. The dimensions of the lipo are based on an Intellect 4400HV4 shorty LCG battery (163g). If you plan to use the center weight, it is possible you have to cut a small fraction of the parts on…
This version use the optional fan shroud fixation but it allows to use a 40mm fan and to hide the ESC cable. You will need two m3x6 screws to fix it.
A sliding custom support for MST TCR, including the parts for TCR and TCR-M, and the shorty and short LCG versions.
To wszystkie aktualnie dostępne wyniki.
