Liczymy pasujące modele…
90-degree adaptor clip for MOLLE system Multiple versions with and without gaps: Regular: small version - fits within one column unit Wide: fits across two columns Wide Groove: has a relief groove to accommodate seam between two columns.…
A housing for a round rocker switch. You can see the dimensions of the switch in the photos. I haven't bothered with a back plate because it's designed to be screwed into the wall. Have added: 4mm Diameter cable version: Inline cable…
These are very simple belt clips to hold molle pouches like this . They're pretty sturdy but how much weight they can hold will depend on how sturdy your belt or pants waistline is. Update - 20/11/2024: Added a slim version Print in…
Three-way connector for 12mm square tubing. One side of the middle doesn't protrude to the edge of the aluminium so that it can be printed without supports. The downside is that it won't look great if used to connect pieces that are…
A clip to hold 30mm tubes I printed in 0.3mm and used supports I printed with PETG for hopefully a little more flex Can accommodate up to 4.5mm wide zip ties and can be mounted horizontal or vertical orientations
Simple back plate for a door knob in art deco style For best results print in resin or finish with filler and paint
Light box version of the classic rave/acid smiley face Best to use reflective aluminium tape on the inside of the frame to improve the reflectivity and enhance the light output/reduce shadows The top section should just friction fit into…
I use a Lumina dehydrator to dry filament but don't want to cut out the middle of the trays to fit the filament in, so here's an extension that sits on the rim of a tray to extend the height of your dehydrator. I've included two versions:…
A case for the GemRed angle finder/protractor. Will need 2 x 35mm M3 screws for the hinges Have included the Fusion360 file so you can adjust the design as preferred
A simple desk stand for a sticky notes pad and a pen. Prints without supports.
Mounts for attachments for the 20L wet/dry Ryobi vacuum Printing in PLA and with 0.3mm layer height is fine. No supports required.
A simple holder for an oil can. Diameter: 70mm Fusion360 file included if you want to adapt it to suit I printed with PETG, 0.3mm layer height
A stand to hold a ring sizing mandrel. The top of the mandrel is held level horizontally to make it easier to work on wax ring designs
Diffusers for the Go Peak Mini Flashlight you can find on Ali Express. Note that these won't fit on the 'fake' Go Peak flashlights that don't have the aluminium lens cap. The knock off ones have a plastic cap with a larger diameter,…
To wszystkie aktualnie dostępne wyniki.
