Liczymy pasujące modele…
I am using Tap on my trident which pushes the hot end forward, thus making a rear nozzle scrubber very difficult to use. Clearances are extremely tight. I added a angle to the front of the brush holder to get the brush as close to the bed…
Modifications by myself: Remixed the inner idler to allow for the use of a 5mm x 18mm pin. Modification by Kermit at Build it Basement : (Updated 2/27/2024. This file is in beta. We believe this newest version is near finalized. Feed back…
This piece is to support the wire channels when doing inverted electronics mod on a Voron Trident. I wanted to keep everything neat and allow an easily removable bottom panel if necessary. ABS or PETG recommended. Check sizing against…
Standard Voron specs Need to use M5 hammer head t nuts for install due to the new extrusion tab added.
An easy way to mount the IKEA EKET shelf to the wall. Print suggestions: 4 perimeters 4 top and bottom layers 20% infill Only hardware you need are some drywall anchors. The ones I used are pictured, but anything similar should work,…
Remixed diffusers for Voron disco sticks
Fantastic original design. I just wanted to open up the bottom for maximum passive cooling and cleaned up a few other things. Category: Model Furniture
This model requires the user to desolder the 90 degree JST connector from the MPX Y end stop PCB and solder in a straight JST connector. If that is above your skill level, this mod may not be for you. You will also need to trim the PCB a…
To wszystkie aktualnie dostępne wyniki.
