Liczymy pasujące modele…
I wanted a nice container for my 24x14" playmat for MTG. I designed 2 different versions, locking and magnetic. The magnetic case uses 6x3mm magnets. MTG emblems on top, bottom, and sides. UPDATE - I've gone through a few iterations and…
You might be able to print in an upright orientation if your printer is tuned. You'll likely need to add a brim for adhesion though. Only supports would be for the fin. Otherwise a raft at a slight angle works.
This protector works for both the HDZero Micro V3 and Walksnail Avatar HD Pro
UPDATE - After some testing I've realized the magnet placement is causing issues with bluetooth reception. The files have been updated and the new solution is tested. I'll update photos soon. This is the 2nd design for my Corne…
I needed to remix a Satsana to fit my Ender 5 with the direct drive adapter kit and a Creality Spider v3 installed. None of the previous shrouds fit my set up just right. I removed a good amount of material to make it slightly lighter and…
The existing mount I used for the Radiomaster RP1 didn't work for the V2 so I designed a replacement.
I redesigned my scrub brush holder to include a sexbolt mount for auto-z-calibration.
I wanted a simple wall mount for my BetaFPV Pavo Pico. It uses the battery bracket to hang.
TPU protector for the RunCam HDZero Nano 90
I ran into an issue where my auto-z-calibration was off due to some nozzle oozing… that caused my previous design to shift after the nozzle offset was too low and the nozzle dug into the bed. As a solution I created this brush mount to…
This mount was designed to fit this MagSafe wall mount. It attaches to the accessory mount on the dash of the 2021 Ford Bronco using this camera knob .
All of the cases that I downloaded for the Corne Split Wireless v4 didn't quite line up. There was something just a bit off. I also don't like having a female/female standoffs sandwiched between the build. So I designed this one with…
This is an improvement on my last design. It has a tighter fit to the bed bracket preventing any movement.
I wanted to create a new case for my Corne Typeractive - Choc split keyboard that provides a slight tenting angle as well as a slight angle towards the typer. It uses heat set inserts, standoffs, and has spots for your rubber feet. This…
This remix lowers the klicky mount point so the nozzle isn't so close to the bed while probing.
I wanted a nice little box to organize my 1S lipos for tinywhoop sessions. Holds 12x1S batteries with a compartment for spent packs.
I recently built the Quadmula Siren F3 Split and loved the TPU profile spacers (PS-3) for securing the TPU mounts without deforming them so I designed arm guards for the Skyliner MKIII that use them.
Most of the TPU mounts that I found for the Go 2 were far too loose for my liking. So I designed this to be more secure.
I couldn't find a wall mount for my GEPRC Cinelog25 V2 so I quickly designed one. Not perfect, but it gets the job done.
Requires 2x PS-2 2x PS-3 Quadmula Profiles Spacers
I needed a good housing for a project I recently finished. https://www.adafruit.com/product/3317?gclid=CjwKCAiAh9qdBhAOEiwAvxIok1zwBzm-fW02TFKCj6RgP7r5Iu9IWKGAiX6j6g4k8Mxsmv12eqKLhhoCj9AQAvD_BwE The link above shows the module that I…
I wanted a clean way to mount our RPM Ropes in our home gym so I designed this simple solution.
To wszystkie aktualnie dostępne wyniki.
