Liczymy pasujące modele…
Yet another caliper holder As I didn't find one for Skådis that uses the T-Nuts from 6d6178 , I took the caliper holder design by KTP, made it thinner and added alignment guides. It can be printed upright without support or brim. The…
Unfortunately for me, I didn't find Dyson accessory holders for Skådis that make use of the phenomenal T-Nuts for Ikea Skadis Pegboards system from 6d6178 . So I had to do them myself. The holders are mounted to the Skådis board with one…
This is a pair of slanted holders for 11 wrenches in size 7 to 19 To attach the holder to the board the T-Nuts for Ikea Skadis Pegboards system from 6d6178 are used. The holders can be printed without support. The shown example was…
As I looked for a simple Skådis pin to hold my steel ruler, I wasn't successful, so I created my own. In the end there were three versions. One straight and two slanted (up- and downwards). To attach the pegs to the board the T-Nuts for…
As much as I like the divided gridfinity boxes for storing screws and nuts etc., it is not easy to empty one compartment without spilling the contents of the other. This simple lid is my solution for a situation like this. As it is…
As almost all Allen keys are different in length of both arms, bending radius (and even angle), it is impossible to use the same tray for two different sets of keys. That was the reason for me to write an open scad script for this…
To attach the holder to the board, one of the T-Nuts for Ikea Skadis Pegboards system from 6d6178 is used. The holder should be printed with support for the alingment pins. The shown example was printed with a 0.28mm layer height. For the…
Mac Studio Dust Prevention As the Mac Studio air intake is at the bottom of the device it is inevitable that dust from the desk is sucked into the computer. I experienced this before with several Mac mini machines. The stand I designed is…
This corner bumper is designed to be printed without any support. It comes in two sizes (40mm and 50mm diameter). To attach it to a corner of your furniture, use double sided adhesive tape.
The breakout board is screwed to the base plate and the breadboard is attached by it's adhesive foam pad. The size of the breakout board is 63mm x 57mm. At the bottom of the plate there are holes for 8mm silicone bumpers.
I have used the simple screwed T-Nuts Hook for Ikea Skadis by Clemi for several use cases on my Skådis board. Unfortunately they were to short for a box of drills, I wanted to hang onto my Skådis board. So I designed two longer versions.
This Trådfri switch holder for Skådis that uses the T-Nuts for Ikea Skadis Pegboards system from 6d6178 . The switch is attached to the holder by a 6mm magnet, so that the metal base plate isn't needed. Details to be mentioned The holders…
For the routing of cables and fixing them on my openGrid, I was looking for a smart removable and reusable alternative to zip-ties or ducts used in underWare. My idea was to use 15mm hook-and-loop cable ties, you can buy by the meter. The…
While looking for a solution to mount my Fritz!Box on OpenGrid, I found that the available models were either overengineered, too bulky, or not reliable enough. Therefore, I came up with the idea of using simple wood screws together with…
After I searched for USB holders to be attached to a monitor I found nothing specific. Only the USB cable organizers by MyStoopidStuff appealed to me but didn't fit my intended purpose. So I decided to modify the three slot version to…
To wszystkie aktualnie dostępne wyniki.
