Liczymy pasujące modele…
My first 3D model is of the Framework laptop and I thought I’d share it here in case it helped anyone. The dimensions should be accurate to +/- 0.5mm, better in smaller areas where I was able to measure with micrometers, say +/- 0.1 mm. I…
This is a simple box for seed packets. It has a tight-fitting lid, making it almost airtight. There are 3 chambers to separate seeds. The sides are angled and the front is low to allow you to read the labels. The lid has a matching angle,…
This is a minimalist stand for the Star Trek original series flip-up communicator. It holds up the communicator at a 45 degree angle for display and the holders stay out of the way as much as possible. It allows the communicator to stay…
This is a downspout guard that fits over a squarish 3" X 3-¼" downspout with multiple rows of drainage holes. The drainage holes on the bottom are flush with the base, which should prevent any water retention. A screw hole is provided for…
This is a mount for attaching Malolo's screw-less / snap fit Raspberry Pi 4 Model B Case (default height) to an Ender 3/V2/Neo/V2 Neo 4040 extrusion, or any other 4040 extrusion with dual 6mm channels. Printed at 0.20mm layer height (or…
The ubiquitous red bodied Redrex aluminum extruder (single or dual gear) has a filament entrance hole that is much higher than the original or all-metal Creality extruder. This is not an issue until you also want to install Creality's…
This is a bracket to mount a 12" Luminiz T512124-F1WWC LED undercabinet light to a Creality Ender 3 V2 Neo. This should also fit the 2020 extrusions on the Creality Ender 3 S1, S1 Plus, CR-M4, CR-6 SE, CR-10 and CR-6 MAX. On these…
This is a mount for attaching Rocky's Updated Pi-4 Case with PoE+ Hat to an Ender 3/V2/Neo/V2 Neo 4040 extrusion, or any other 4040 extrusion with dual 6mm channels. Printed at 0.20mm layer height (or 0.28mm, it doesn't need to be pretty)…
To wszystkie aktualnie dostępne wyniki.
