Liczymy pasujące modele…
After two failed attempts to make a foot replacement with flexible tabs like the stock part, I decided to go for a threaded option with a nut. works great, requires taking a side off the case to install the nut but at least it doesn't…
Designed this to keep my build sheets somewhere out of the way. I print on top of a metal 2-drawer filing cabinet and now I can keep up to 4 sheets out of the way but nearby. I printed with a 0.6mm nozzle, 0.3mm layer height, 0% infill…
I had a push broom with a squeegee blade for my garage that I hang bristle side up. Snow melt ended up causing rust near the original handle, which cracked from the metal swelling. This replacement has a hole to let any moisture out. I…
A spacer to keep an expandable bamboo silverware drawer insert from sliding around within the drawer. Scale to size in slicer. Insert at back of drawer. Print instructions THIS MODEL REQUIRES SCALING IN SLICER I used calipers to get the…
This model was created to hold nine 10ml Schott vials with 22.75mm diameter. Use stick on rubber feet to keep it from sliding around, works great on shaker table.
I had a problem with a Microsoft Surface device overheating, pointing fans at the back of it kept running a lot nicer. I used a set of 2 USB powered fans off amazon but should fit any 80mm fans. This holder angles the fans up.
Raises the Decontaminator brush mount up 15mm to work with kinematic bed mount. update 2025-01-20: added standalone endstop. print on side.
Wanted to turn my ESP32-S3 4.3inch Capacitive Touch Display Development Board into something like a streamdeck, finally got around to 3D modeling a case. use M2.5 bolts and some washers on the right side to get the spacing dialed in. i…
Whiteboard marker caddy that sticks on with magnets. Slots for your fingers to help lift markers out, so you don't have to go digging around. Prints with no supports if you orient it opening against the print bed. NOTE: My whiteboard is…
After bumping my ChargePoint home flex with a trash can and hearing the receptacle slam into the ground, I found that one of the hinge tabs had sheared clean off. This replacement pin seems to work well. I printed it laying down which…
Fusion files and step files for Lemongrab heads I made for my family. Split the nose in half, print on the split, superglue back together.
There's a little plastic piece that holds the spinning arm in labconco steamscrubbers that can crack. Printing this in ASA, PA12 or something else resistant to heat and moisture is mandatory. For FDM printing orientation I'd recommend…
To wszystkie aktualnie dostępne wyniki.
