Liczymy pasujące modele…
Easy to use picture hanging tool. Just hang the first picture of several. To get the same hight for the second use this tool and adjust the height. While holding the tool remove the picture and make a marking on the wall.
Simple holder for charging 18650 batteries in original battery holder and TP4056. Be careful when pressing down the battery holder so that the cables doesn't get squeezed. The chip I use have the positive pad on the left side, please…
A ventilationgrill to put inside a 100mm pipe and glue with silicone.
This is not a remodel this is a add-On. Its a simple key so the kids simply can remove the handle. Remove the red part shown in the picture form both sides with a knife. Its just a 5 min Tinkercad solution for my kids that I share. And we…
Third reality garage tilt sensor holder with lock function so the sensor doesn't fall out the the garage door is in the open state. Glue with silicone (easy to remove) or screw in the top of the garage door
A wall holder for 7 AutoSoft 90 infusion sets that can be mounded strait or in 90 degree (as in the picture). Its only 7 because the hight between my shelf in my wardrobe. Mirror the 90 degree if you have the wall on the left side.
Holder to Google mini for IKEA Kungsfors. You can wind excessive cable around the base. You need 2 M3 20mm or 25mm (little to long) and two M3 bolts. The holder is a remix Jonas Hanssons (Pawpawpaw85 on thingiverse) wall mount for a…
A container for meat string roll. I liked Marc container but it was to small so this is a remix of his work with a hole in the lid for the string and its 1.8cm higher. It fits meat string rolls that are 10cm high and diameter of 6-6.5 cm
To wszystkie aktualnie dostępne wyniki.
