Liczymy pasujące modele…
The camera inside the printer is almost useless, focus is lacking and light causes the background to over darken and you can not see anything. I created this mount for my Wyze Cam v4, I think it should also fit a v3, but I don't have a v3…
The camera inside the printer is almost useless, focus is lacking and light causes the background to over darken and you can not see anything. I created this mount for my Wyze Cam v4, I think it should also fit a v3, but I don't have a v3…
This tested and fit a ¾" electrical box. I printed in PLA for indoor use, but I would use PETG for outdoor. I haven't tested this for water tight but it is similar in design from what you get off of Amazon which claims to be water tight.…
This tested and fit a ½" electrical box. I printed in PLA for indoor use, but I would use PETG for outdoor. I haven't tested this for water tight but it is similar in design from what you get off of Amazon which claims to be water tight.…
Sprinkler head grass protector for rainbird 3500 or 32sa, it keeps the grass from getting caught by the sprinkler rotating head. I printed mine with PLA, but I will be reprinting it in PETG because it is going to be outside in the sun.…
It is just like all other horizontal battery mount except this fits the SeeSii 21V Batteries. I didn't see any available and since their battery is proprietary, I made one for it. I also made the tool mount using the battery slots:…
I created a small cover with wall mounting brackets for outside. The wall mounting bracket should fit wooden shingles or vinyl siding. The smaller cover gives 156mm of covering. The larger covering gives about 210mm of covering, due to…
Just like most drills or other battery tools that is mounted and held up using their battery slots. I didn't see any available for SeeSii 21V and since their battery is proprietary, so would the battery slot, so I made one for it. I also…
The camera inside the printer is almost useless, focus is lacking and light causes the background to over darken and you can not see anything. I created this mount for my Eufy C120 based on measurement listed online The mount uses the…
I made a few changes to suit my want. I did not want to put any screws into my wall or furniture. So I made it similar to a clamp clipping onto a 1" horizontal edge. Another big difference is, my battery holder slot was only 55mm wide…
I started this as a masonic gavel, but realized this can be used as a mallet for anything that I don't want to marred the surface with. Such as woodworking or assembling 3D models. The caps has a hollow center where you can put tiny ball…
To wszystkie aktualnie dostępne wyniki.
