Liczymy pasujące modele…
So, i had to replace the 40 yo. pulley from the top of the mast of my boat and i decided to print one. I decided to make a bearing pulley so it would run smoother. It has very tight tolerances so you have to break the gears free with a…
Wind scoop / wind shovel / windschaufel Measurements are in the pdf file!!! Print with UV resistant material and with support!
Its just a decorative voronoi cube, printable without support. I upscaled it to around 400%. There are 2 versions, one of them has thicker / stronger lines! Settings: Material: Pla Temp: Bed temp 55°, nozzle 220° Layer height: 0.2mm…
Gopro hero 9 black lens protector, print in place.
Its a card holder i made with space for pens / pencils, printable without support! My print settings: Material: Pla Infill: 15% Layer height: 0.2mm Temp: Bed 55°, nozzle 220° Support: No support needed
There are 2 versions of the keychains, just print whatever you like more. There is a multi colored 3mf file if you need it. :)
Impossible table (wire needed)
Hello, i made a 3d printed drone with a tbs source one v5 frame but it wasn't stiff enough out of pla. So i made this reinforcement frame wich makes it way stronger and adds not that much weight. i printed it out of PLA with 100% infill…
The mode needs to be downscaled to 10% in the slicer!!! My print settings: Material: Pla Infill: 15% Layer height: 0.2mm Temp: Bed 55°, nozzle 220° Support: No support needed
To wszystkie aktualnie dostępne wyniki.
