Liczymy pasujące modele…
When I printed the “wago” mount for my Voron 2.4 build, I found my connectors did not fit the slots on the model. I realized the clips I had were knockoffs and not Wago by brand, however even the measured size of the slots is smaller than…
The DIN mounts in the Voron 2.4 R2 build increase the separation between the electronics and the DIN rail. Given the additional height, it didn't make sense to drop the wires to the panel to tie them off, so I made a tie down point along…
During my Salad Fork v1.1 build, I realized that the feet shipped with the kit were WAY too big, intended for full-size Voron machines, not the 3D Printers for Ants size feet. To avoid pausing the build longer than necessary, I whipped…
The Story Once I completed the first corner joint of my Salad Fork build, I lifted the corner to inspect the alignment and listened with horror as 15 preloaded nuts bounced off a messy craft room hardwood floor and to parts unknown. A…
To wszystkie aktualnie dostępne wyniki.
