P
PrintablesFabio Falcinelli
Toyota Yaris windscreen wiper endcap
A simple cover for windscreen wipers since the hail broke them. It could fit other makes, let me know it and share them!
- Pobrania
- 128
- Polubienia
- 20
- Ocena
- 5
Wszystkie modele
Liczymy pasujące modele…
P
PrintablesFabio Falcinelli
Tefal Steam Cuisine Knob
That's a simple knob to replace the broken one on my Tefal Steam Cuisine. The 0 is not really in vertical position, I'll do another model later. I print it upside down, with PETG, I don't know if the axle inside would became too hot for…
- Pobrania
- 54
- Polubienia
- 2
- Ocena
- 0
P
PrintablesFabio Falcinelli
Bosch AFS 23-37 Brushcutter wire holder
A wire holder for Bosch AFS 23-37 electric brushcutter. With this I can use normal 3mm diameter wire with my brushcutter, avoiding bosch expensive spares. I print it using PETG with a 0.4 nozzle, flat side with the hole layed on the bed.…
- Pobrania
- 34
- Polubienia
- 4
- Ocena
- 0
P
PrintablesFabio Falcinelli
Elecrow 5 Ball Mount
This is a ball mount for the Elecrow 5" touch display with this cover: https://www.printables.com/model/85017-elecrow-5inch-hdmi-display-b-case The ball mount is compatible with this mounting system:…
- Pobrania
- 28
- Polubienia
- 6
- Ocena
- 0
P
PrintablesFabio Falcinelli
Anycubic Kossel E3D Revo Six hole adapter
I noticed too much air was flowing to the heatbed even if part cooler was off. Then I designed and printed this simple adapter so that the hole fits better and not too much gap is left around the revo six. Print with a material resistant…
- Pobrania
- 16
- Polubienia
- 6
- Ocena
- 0
P
PrintablesFabio Falcinelli
Anycubic Kossel 4020 part cooler kit
I wanted to increase the air flow so that bridging would finally work. I found a lot of adapters, but somehow I was always missing a part. I printed this in PETG, so that is bit of elasticity is given to the cable holder. I'm thinking to…
- Pobrania
- 12
- Polubienia
- 2
- Ocena
- 0
P
PrintablesFabio Falcinelli
Tush Knitting Needles Rails
I'd like to fix my spools to the table so that they would not move, you know, sometimes it just happens… I used M5x30mm screws and 2 knitting needles to implement the rails. I modified the TUSH so that it anchors to the rails and can…
- Pobrania
- 10
- Polubienia
- 5
- Ocena
- 0
P
PrintablesFabio Falcinelli
Chlorinator pipe block
This chlorinator hose lock is used to hold the hose in place in the water tank.
- Pobrania
- 3
- Polubienia
- 0
- Ocena
- 0
To wszystkie aktualnie dostępne wyniki.