Liczymy pasujące modele…
Made this in light of the original reason this system was created. to get rid of the cheap crappy containers you get your screws in! Paired with the screw sorter from the link below, you're bound to enjoy using this system….. even if you…
Wydruk około 1,82 €–2,23 € nettoWstępna wycena jednego wariantu
Have 99 cables but a wrap ain't 1? Remade Ridiculous' model to have only one side have the cutout for the cable ends to avoid bridging or supports. Also rounded edges quite a bit on entry areas to relieve some stress on the cables
Simple fidget spinner that uses a typical 608Z bearing. Using bearing on the outside holes adds weight making spinning it more satisfying. Good use for bad/used bearings that you dont wanna toss
Just a simple, low filament dryer knob to replace the ones that crack and break. fits on VERY snug as intended. use a plastic hammer and lightly tap it on fully, itll seat. havent used yet. just installed, will update this with results…
Just a quick PS4 mount i threw together Note: This is not long-term tested. i mounted my PS4 with this on 2-1-2026. if i dont update this, it probably held up fine.
To wszystkie aktualnie dostępne wyniki.
