Liczymy pasujące modele…
I needed a simple way to hang my water bladders out to dry. So far this fits two different CamelBak and one Osprey. Printed in Hatchbox Yellow PLA at .2mm and 50% infill
I printed mine in PLA at 15% infill with no brim. Orient the print with magnets facing up worked best for me. Fits 6mm x 2mm magnets. Make sure to be consistent about magnet placement - I did positive facing out on the bumps, negative…
I wanted to prevent my Wham Bam HotBox from moving around when I open it up. These slide under the bottom walls and can be attached to your table with double-sided tape. Prints four nicely at .3 layer height, 15% infill, no supports.…
To wszystkie aktualnie dostępne wyniki.
