Liczymy pasujące modele…
This is a big planter! I used 0,8mm nozzle with 0,4mm layer height for faster printing speed and to make the layer lines show better, but standard nozzle would probably work fine. Prints without supports, but lots of overhangs so slow…
Recommend lightning infill or low percentage regular infill for faster print speed. Lots of overhangs. Use low speed and sufficient cooling. Printed at 4 perimeters, 4 bottom layers and 5 top layers and this made it watertight. If leaking…
A remix of two multimeter holders. Works on IKEA skadis pegboard using the “Ikea Skadis clip” design by ByteSlinger.
Small holder for square handle picks with dimensions of 13.3 x 13.3mm at the handle. Requires supports at mounting hooks
Made a quick remix to mount the camera to one of the poles (16mm) in Creality's enclosure tents. May need som sanding to fit.
Case made to fit my adapter from ThePiHut: https://thepihut.com/products/ssd-to-usb-3-0-cable-for-raspberry-pi No supports needed
Print lying down. No supports. Update 29.09.24: Added short version
Stands for both containers and lids
Lokk som lar flasken stå opp ned. Anbefaller supports
Probably don't need supports, but I added this for the bottom hole to ensure good strength for the above stand-base. Top part is superglued to the stand. The IKEA charger has a snug fit. The original apple MagSafe charger has a loose fit…
Skadis mount for turbofans with dimensions 28x46.5mm. No supports
Big holder uses 14mm wooden dowels. Small holder uses 10mm dowels.
I lost my original backplate and needed one for mounting my smoke detector with a magnet
To wszystkie aktualnie dostępne wyniki.
