Liczymy pasujące modele…
Not enough room on your windowsill? This is a simple extension for the " Self-Wattering Seed Starter " that allows you to place the trays on top of each other. At the same time, you can wrap them in kitchen foil to act as a small…
EN The rails are designed to be screwed with 3 wood screws. Each piece is 21 cm long and can be easily stacked. I use thin plexiglass as the door, but anything up to 4,5 mm thick can be used (I don't recommend wood which expands when wet…
Náhradní ovládací knoflík pro Tefal mixer. Originální se nám zlomil po týdnu používání. Tak kdybychom náhodou nebyli jediní :) EN: Replacement control knob for Tefal blender. The original one broke after a week of use. Just in case we…
Replaceement for original Chariot CX part, for mounting the Ski Kit on the Axle. For drum brake models. Printed with 0,16 layer height, 3 perimeters and 40 % gyroid infill.
Remix Mini-Me Hotend Duct to better fit Elegoo Neptune 2s It should work with Neptune 2, but I'm not 100% sure the backplate is the same on both machines. The only change from the original is that I made the mounting holes a little…
Obal na Poke 4 lite s krytem pro bezpečný transport. Model jsem vytvořil pro připevnění na pultík pro paragliding, ale určitě se hodí i například na cestování. Zatím jsem netestoval ve vzduchu ale čtečka v obalu drží hodně pevně. Nahoře i…
EN: The plant seedling label is a practical and ecological accessory for every gardener. The label consists of two parts: a solid part that is stuck into the ground and a slip-on part made of transparent material that protects the paper…
Riser holder for little Bluetooth remote i bought on Aliexpress. It can be printed without any supports. Recomanded material is PETG.
This is a Garmin Fenix 6 holder designed for a bike stem. It’s specifically made for the stem with a flat top side and grooves along the sides for elastic bands.
To wszystkie aktualnie dostępne wyniki.
