Liczymy pasujące modele…
I failed the print of the box for the original model 4 times due to the lever/hinge printing in thin air + being a small, rounded, over-hang. This is a good receipe for failure, at least at higher speeds. Instead of slowing the print down…
My mod is greatly inspired by some commercially available one but I've modeled it myself from the ground up and took the liberty of adjusting it to my liking. This mod will make the braking more linear and less stiff overall which is what…
Changelog v3 Release Removed the need for supports using the bore trick Adjusted some bridge problem above the MCU housing Removed front mounting solution with M3 Changelog v2 Release Added a cover on the top with a + and - sign The deck…
This is a simple plug to fill the hole left after removing the rear wiper blade on an EK chassis civic. Probably compatible with other 6th gen Civic, but I don't know for sure. Print in TPU. No supports needed. It is a very very tight fit…
Print in place Cut a piece of paper to length Add tape on the paper to make it less easy to bed/mess up Slide bottom of the paper in first, then slide in the front of it Add LEDs well wrapped up with the battery holder in its housing…
For the G27 version, this one is un-tested, if you do make it please reach out to me with the required adjustements. This handbrake has been inspired by other models out there. My main perks with this one are: Precise measurements,…
Wanted to mount this under my desk so I needed something to do that and thought it'd be good practice to model it myself so here it is. Should fit most usb Hubs that are ~30mm deep Update: Added step file for easyer modification
Modeled this to fit a 16mm tube that I use as a handbrake for my sim “rig”, so that is why the handle is round and not flat as it should be Can be scaled to fit some other accessory to use in a cosplay or to also use as a handbrake handle…
There are plenty of available button boxes but none that I either liked or could build with the hardware I had at hand. Also it is always good practice to model stuff yourself ! BOM 1 * Zero Delay Arcade USB Encoder/PCB ( AliExpress ) 12…
My wheel didn't come with a cap so it bothered me to see the bear podium behind it. Quickly modeled a cap to use the remaining 3 screws in the middle to solve this. Meant to be printed with .2 layer height, in the position provided. Play…
My kitten kept pulling on the cahrcoal filter to eat it so I had to come up with a solution to try and prevent this. Apparently its fairly common for cats to do that. This fits my specific litter box but I'm sure other can edit it to fit…
To wszystkie aktualnie dostępne wyniki.
