Liczymy pasujące modele…
Two piece magnetic scissor holder, using 10x2mm round magnets. The two pieces interlock but should be glued together for best results. The magnets are intended to be glued in the recesses in the back. I used a gel superglue and the…
This started out as a minor modification to Titan's existing design for a friend and quickly snowballed in to nearly a complete redesign. What was changed. -Fixed a ton of miscellaneous geometry errors. -Rebuilt factory switch sockets.…
This is just a modified version of my existing switch plate that uses six factory switches and the lighter plug. While you can bridge the openings for the factory switch latches, you get better results with supports. That said, I…
A bench top stand for a Worx WX240L Cordless Screwdriver and the included bits. .4mm nozzle .3 mm layer height, I used paint on supports in the section for the screwdriver and manually changed the "Pattern Angle" so they would run…
A minimalist bench riser for an Arduino Uno Rev3. Simply intended to keep the Arduino up off the worksurface and thus minimize possibility of contact shorts or damage to the bottom of the board. Raised guide pins on the mount locate the…
Simple magnetic parallel holders made with 10mm x 2mm round magnets. Intended for use with all the sizes in a typical 1/8in parallel set, with 1/2in being the shortest they are designed to work with. Holes are designed so the magnets…
To wszystkie aktualnie dostępne wyniki.
