Liczymy pasujące modele…
Printing instructions: Quality: .12 Walls: 3 Infill: 40 Pattern: Grid Temp: 210 and 60 Speed: 80 print speed and 40 walls No support Raft - Optional Link to the video: Note: I didn't make this model, just uploading it here, since it's…
This is a double color flexi trilobite from prehistoric ages :) Note that I put three models on the plate, to reduce filament waste by colour swapping :)
Custom stepper holder for V400. It doesn't make contact with the shaft and the bearing on it, as it's main reason for increased ringing artefacts and noise levels. Print in PETG, ABS or ASA. Min 40% infill. I recommend replacing the stock…
Allows to mount 90/92mm fan inside for better cooling (temp stays below 35C) You need: 90mm fan - I used brand Artic, model PWM 12V (PC case fan) 2x30mm M3 screw 2x10mm M3 screw 2xM3 nut And some raisers to make the top a little bit higher.
Simple and fast mount of FYSECT ADXL to the FLSUN V400. No need to cut the ADXL's PCB. It's a tight fit the to fan, so I suggest to print it with “Outside walls first” option set in the slicer, so it's dimensionally correct. You need: 2x…
Replaces the pneumatic hose fitting with leftover part from Dragon hotend (the top of the heatsink)
Replaces the pneumatic hose fitting with leftover part from Rapido (the top of the heatsink)
This mod allows you to add 5015 fans to cool down the stepper motors and the electronics. It makes your printer live longer and avoids skipped steps due stepper motors overheating. Print with 0.2 layer height, 4 perimeters and 40% infill.…
Pokud mate TV od PODY, pravdepodobne mate tento ovladač :) Kryt na ovladač. Arris VIP1113 baterry cover byWinCZikis
This adapter allows you to install BTT Octopus motherboard to FLSUN V400. Requires 4x M3 heat inserts.
Raises the top HUB board into vertical position for easier maintenance, if your have the printer on the floor, like I do. You need: 4x 8mm or 6mm M3 screw 2x M3 nut I used 8mm screws, to add some flexiness to the raiser
This mod replaces the PTFE tube with POM wheels, which allows much more smooth movement of the spool. BOM: 6x POM wheel 2x 40mm pin (5mm shaft) or 80-85mm rod (steel, carbon, titan)
Allows you to mount the Nevermore filter using magnets to the top of FLSUN printer You will need: 2xM3 14mm screws 2xMS nuts 5x 8x3 magnets - Use some glue if you want to secure them, however they hold with friction as well Print with…
Minicake cutter / Vykrajovatko na mini dortiky - 6x6 cm Print with PLA. 0.2 layer height, other settings are up to you. Without supports and brim. Výtisk z PLA. 0.2 vrstva, zbytek nastaveni je sumafuk. Bez podpor a brimu.
To wszystkie aktualnie dostępne wyniki.
