Liczymy pasujące modele…
A fully filled front visor piece to allow stacking (courtesy of my daughter Amy age 11). Added 2 and 10 stack versions of the solid one (apologies messed up on the original stack files - these are updated) Added open skeleton and open…
Prusa faceshied in the speedprint format modified for a standard four hole A4 hole punch. (888 - 80mm between all holes - not the 80-60-80 of the prusa). Added stacks for a 0.3mm layer height in 2 (to test) and 15. ie only print with a…
The box design is very good so only needed 2 perimeters and 5% infill (bridging mode on ). 0.2mm layer height. Could do with a bit more tolerance top and bottom on the round wooden handle but there's enough give to latch it.
Instead of the plunger this is a sizeable bellows I use with a dosing cup (might be a bit much for grinding into a filter - not sure but easily cut down). Its 0.6mm thick in the bellows at the thinnest part with thicker base to insert…
Snap fit housing for standard usb breakouts - solder data and ground but leave the voltage disconnected. My print is bit rough on the snap fit as I used a 0.6mm nozzle and would benefit from a 0.4mm Tinkercad link:…
To wszystkie aktualnie dostępne wyniki.
