Liczymy pasujące modele…
This is a a stand I built to elevate a small 12 channel audio mixer, Behringer 12 XENYX. If you print this using the stl files, you will need to create two sides with one mirrored. Don't worry about cleanup, the little bit of elephant…
This is an ok sounding portable Airplay speaker. Print instructions I printed this at 0.3 layer height with no supports because I'm impatient and I knew I was going to paint it. The USB C charger board is a real tight fit, once your…
I love my little blower for getting rid of sawdust from the garage, but the inlet is on the left side and is always getting stuck on my shirt. I'm sure that I am losing a little efficiency with this, but it still works for my needs. Print…
This is a handlebar mounted basket for a small Razor scooter. The bracket attaches with two zip ties. The bracket has a recess for a captured nut and the knob accepts a bolt. There are four really small holes for attaching short lengths…
I had two 1 inch cube rare-earth magnets that i got from amazon for pretty cheap and have wanted to make a knife sharpener for a while. The magnets are epoxied from underneath and there are little channels to allow the excess epoxy out.…
It's split into two pieces so it can be printed without supports. You will need three m3 heat set inserts along with three short m3 screws for mounting the top half. Screw the bracket part in with two #6 coarse threaded screws into the…
This is an old car part that someone asked me to design so they can mount their motometer (old time temperature gauge) collection. I haven't printed this yet, not even sure if It can :) Category: Automotive
To wszystkie aktualnie dostępne wyniki.
