19 modeli
Tired of spinning a fidget? Well, here's one fidget to make you change gears the whole time :-) :-) Just use a small piece of 1.75mm filament at the joints and another small piece for the knob + small bit of glue. Enjoy !!!
Use your index finger and thumb to close both sides :-)
A collection of 12 810 "Goon" styled drip tips.The different versions of each has small differences in design :-)
I needed to clamp some corners while the glue is drying and started designing ones that can be used with one normal g-clamp.
Rocking chair for doll house. Printed all parts and some glue to keep them together. Print instructions Print all parts and then add some glue to keep them together.
Replacement part for Hyundai Getz sun visor clip. Re-designed the small clip that broke with a sturdier design.
Filament guide for Prusa I3 (3mm & 6mm frame) Print in place.
Made to fit Hyundai Santa Fe badge, but should fit other by resizing. Some minor sanding might be required to make them fit perfectly.
How about a nice puzzle frame for all your memorable memories :-) I used some superglue to hold the puzzle pieces together. Beware, each puzzle piece is different :-)
Turn your eraser into a hammer and stick it on the back of your pencil :-) Eraser size 10mm x 10mm x (the length is up to you ;-) )
Toy cot for doll house. Print two of the long sides, two of the short sides and finally the bottom. Glue them together and there you go. Hope this will bring joy to the girls. Print instructions Print two of the long sides, two of the…
Ever wanted to cut your RDA's / RTA's coils the same length? Well now you can print this and choice your length :-) Just through your coils in the slot of your choice and cut it at the bottom.
Designed off of the MoFang Jiaoshi SQ-1 cube. Tolerances is a bit small for my printer, might be the bigger nozzle :-) Will still try with my .3mm nozzle and smaller layer high. The hole for the screw is made so I can increase if necessary.
Designed to fit "Bic" pen style refill.
Made for a "Bic" pen style refill. Printed front part laying down. Some super glue used to bond two parts together.
This is a badge to close the extra two holes on the towbar. Also included a blank back plate if you wish to add your own vehicle logo or if you just like it plain :-)
If you feel like using a geared extruder on your Thing-O-Matic printer, well your in luck :-)
To wszystkie aktualnie dostępne wyniki.
