Liczymy pasujące modele…
A simple and small clip which can be glued to the inside of your FPV plane to hold 2.4Ghz aerials securely in place without having to tape them down. The antenna used in the photo is from a BetaFPV SuperD diversity transceiver– The clip…
This simple panning camera mount is designed to require no foam-cutting whatsoever in its installation for those of us that don't want to be committed to a camera setup. Simply install the servo into the cover, and glue the bottom of the…
I encountered slippage issues between the 12V 7RPM spool winding motor's shaft and the PETG/PLA motor joint as the plastic was not strong enough to handle the torque and it would yield after a short period in a high friction system like…
This structure adds chambers and pathways to your 100x50mm formicarium, enabling your ant colony to properly adapt to and partition the space. The maze is 20mm tall and meant to be used with this formicarium…
The T-1 Ranger, albeit an excellent FPV plane, is built like a sealed oyster with very few places for air to escape. This causes two problems: 1. Hot air accumulates inside of the cabin which prevents the VTX from cooling down properly as…
This lightweight bracket glues onto your 20x20 fan and allows for it to be bolted directly to the VTX. This model requires supports due to its geometry.
My old remix that used washers eventually gave out on me as the iron and plastic buckled under the immense stress they were not meant to resist. This remix is meant to work with 4x M3 bolts attached to a 6mm flange. Link to 6mm flange I…
This is a simple plate that will securely hold a Matek WLITE flight controller along with a receiver ziptied beneath it to save space/make wiring tidier. It is intended for Olivier C's 3D printed Sabre FPV plane.…
Improve your building's accessibility by printing and installing these office number placards on each door to allow the visually impaired to navigate their way inside of the building. Compatible with most braille alphabets, check before…
The skid of my chair broke and I modeled a replacement one. While unlikely, I am publishing this for anybody that may need it. Print it with a high number of walls along with 80-100% infill. The angle is slightly off but over time…
To wszystkie aktualnie dostępne wyniki.
