Liczymy pasujące modele…
I designed a 3D-printed version of a spinning skein holder. The spindle is held captive by a small keyed shaft pressed into a 608 bearing. Print Settings: 0.4mm nozzle 0.2mm layer height Supports only on spindle and spindle peg 15-20%…
Wider and more stout than my last one, this screw container is intended for storing small items, like beads. Print Settings: 0.4mm nozzle 0.2mm layer height No supports 15% infill
The official Cisco part for wall-mounting 7800-series IP phones has been getting increasingly scarce and expensive as of late, so I set out to make a 3D-printed alternative for use at work. Additional Materials Needed: - 2x M3x6 machine…
A basic planter which was designed for small succulents. It features a removable drainage grille and a dish which keeps the pot registered in the center. Print Settings: 0.4mm nozzle 0.2mm layer height 3 perimeters No supports 20% infill
Simple screw-top container for storage. Print Settings: 0.4mm nozzle 0.2mm layer height No supports 15% infill
This knob is similar to the stock one that comes installed on the SV06, but without any logo. Print Settings: 0.4mm nozzle 0.2mm layer height No supports 15% infill Print the model on its face (female spline cutout facing up)
One evening while dropping my earplugs repeatedly whilst trying to get into bed (which are IMPOSSIBLE to recover quickly if you're sufficiently nearsighted, by the way) I had the idea for my ideal earplug container which would be easy to…
To wszystkie aktualnie dostępne wyniki.
