Liczymy pasujące modele…
This part allows the installation of the Orbiter V2 extruder on Ender3 V2's tool head. Additional parts required: 4x M3x16mm bolts 2x M3 nuts See the attached picture for the correct orientation of the part while printing. The reason for…
This is a simple 4X4 wheeled robot that is powered using 4 N20 motors. An MX1508 motor driver is used to drive the motors, other similar motor drivers can also be used. An ESP8266 microcontroller is used to control the robot via a web…
This mount enables the installation of a geared DC motor( 33GB-520 ) in the Carduino at the place of the BLDC motor. You can install either the smaller or larger gear depending on the speed and torque requirements(Higher speed will reduce…
Can be printed in any material. PLA is recommended for indoor use, use PETG or ABS for better heat resistance. ASA is recommended if the part will be used outdoors, especially under direct sunlight.
This part replaces the idler mount from this project to allow the installation of a 400mm linear rail, this enables the left toolhead to be able to print on the entire print area of the printer when the right toolhead is parked.
This mount replaces two frame joiner pieces on the left of the top frame of a Rook 180 and allows the installation of an Ender3 Bowden extruder. Recommended printing orientation is given in one of the pictures.
This mount allows a BTT Octopus board to be mounted on a linear rod.
To wszystkie aktualnie dostępne wyniki.
