Liczymy pasujące modele…
I bought a Prusa Mini specifically for its small footprint so I could bring it with me when I travel. To keep the mechanisms from moving around in the car I have designed transport locks for all three axes. Print instructions The Z should…
A cap for a BNC female connector. I've remixed it to add a retaining ring. Credit to ItzKCase for the original model, which can be found here: https://www.thingiverse.com/thing:5276197 Printed in TPU.
This is a desktop stand for a handheld amateur radio. This one is printed in PETG. UPDATE: version 3 has had the space at the bottom extended to accommodate the battery latch for the Yaesu FT-60. The bottom of the stand is also thinner to…
A cap to protect a SO-239 connector. With a retaining loop. Printed in TPU.
UPDATE: changed design to print without supports. This leads to an easier and cleaner print. Printed in PETG. This is a power/volume knob I designed for the Yaesu FT-60. I printed mine in TPU but I think PETG would work also. This knob…
A thing to push up the wipes in the box as they get low so they don't fall down. Printed in PETG.
Yaesu FT-818 microphone holder for the Portable Zero side rails. Should work on the FT-817 also. Uses two 13mm x 3mm neodymium magnets held in with superglue. Print magnet side down. I have included integrated supports so no additional…
Yaesu FT-857 microphone holder for the Portable Zero side rails. Uses two 13mm x 3mm neodymium magnets held in with superglue. Print magnet side down. I have included integrated supports so no additional supports are needed. Optimized for…
Replacement volume knob for the D700 with indicators for knob position. Printed in PETG with a color change. Supports along the outer edge only, not the center. Printed with 0.4 mm nozzle at 0.1 mm layer height.
A cover for the Key, DATA, and ACC ports on the rear of the Yaesu FT-818. Should also fit the FT-817. Printed in TPU.
This is an improved pole mount for the Mikrotik RBSXTsqG-5acD-US. I will be using this for a portable AREDN station. I remixed the pivot assembly from the original by JoeleDixie I found on thingiverse. Printed in CC3D PETG with 3 walls…
I had problems with the original fan duct pivoting on the screw and hitting the print. I have modified the fan duct and the hot end mount to have two points of attachment. The hot end mount is in PETG. The fan duct is in ASA. I tried the…
UPDATE 27 December 2022: Added a file with spaces for two 12 x 3mm magnets to secure the base to a radio. This is a base for a Soviet-era mini Morse code key. The base of the key has a trapezoidal plate to fit into a radio or a knee…
This is a reverse engineered bushing for a SteppIR antenna. SteppIR calls it a Sweep Diverter. Because the thickness of the paint over the fiberglass rods can be inconsistent the printer is encouraged to print one and dry fit it. I had to…
To wszystkie aktualnie dostępne wyniki.
