Liczymy pasujące modele…
In general: Print one of each. Put Velcro through the channel and put it on the board. Fasten the power brick with Velcro. Velcro channels are 15mm wide and 1.5mm deep. That is 150/254 inch by 15/254 inch if you prefer fractions and…
Print standing up with support. PLA worked fine for me. Add felt stickers on the bottom if you like.
Quick CAD. Does the job good enough for me. Could probably be optimized but is hidden by the motherboard. Print 6 standoffs and 1 base. I printed it all in PETG for the heat resistance. Mount the motherboard using M3 screws from the back.…
Intended usage When prototyping with modules I find it hard to have a good way to mount them. That is where this comes into play. You need three categories of parts: Grid: The grid that everything mounts to PCB Backboard: The mount for…
I printed it upside down with support. The cover stays put because it slightly deforms the nose cone. This allows it to be printed in any material.
To wszystkie aktualnie dostępne wyniki.
