Liczymy pasujące modele…
A modified 3-gang wall plate I modeled from a standard one so it would fit on my wall where the trim is a bit too close, so a standard plate would not fit and look good at the same time Note that you should follow all building and…
Hi! I modeled this to attach my AC-Infinity flexible ducting to a piece of plywood that fits inside a sliding window, so that I didn't have to make a hole in my garage wall just yet. It is EXTREMELY tight, so be careful. It prints just…
I modeled these rollers from the kitchen rollers I have. They work much better than not having rollers, but not as good as the original! I didn't spend a lot of time getting the print perfect, but I'm happy with it. You'll need two flat,…
Hello! My brother in law drew up this design, and I modeled it. Printed in black PLA in two pieces, which are super-glued together, they've held up for years! There are holes in the back for screws, or probably just use some 3M strips :)…
A couple of 1" PVC pipe (white stuff at least in Canada where I am) flanges I made to build a cat tower using some 1" PVC pipe I had. Works quite well. There are three screw holes of 3/16" diameter each. I printed it in PLA, it worked…
Hi fellow Nintendo enthusiast! I modeled this Koopa shell to give out as first and second place prizes for my New Year's Eve Mario Kart tournament! First place got Red shell, second place got Green shell (could make it Blue shell, Red…
Bracket that snaps in a filter cover for a hot tub - fits Bullfrog spas X5L but I don't know about others, that's the one I modeled it for. Printed in PLA without supports, it seems to work well. I recommend putting it near the hot tub…
A rolling pin spacer I modeled to fit my rolling pin and provide 1cm of space between it and the counter. Print two! The fit is amazing on my rolling pin with 68mm diameter handles. It is slightly compliant. Doubles as a small coaster…
Hello fellow Nintendo enthusiast! I modeled this decorative bobomb cabinet pull to fit my custom Nintendo themed arcade cabinet. It came out wonderfully! Instructions: PLA, high resolution White PLA for the eyes Gold/Bronze/Yellow/ or…
Hello fellow Nintendo enthusiast! I modeled this Mario cloud with an embedded cylindrical magnet of size 18mm diameter and 5mm depth. I use four of them to hold up the acrylic marquee on my custom arcade cabinet and they turned out…
Hi! I modeled this knob with a hollow for a ¼" hex shank - I wanted a dedicated tool to install and remove my 3d printer nozzles that would fit easily under the extruder, and also to not conduct the heat into my fingers. Some things to…
Hi fellow Nintendo enthusiast! I modeled this Mario super mushroom to act as a decorative speaker-grille for my custom arcade cabinet. I printed it in three colours: Red, then light peach colour, then black. It turned out great! I glued…
Hello fellow Nintendo enthusiast! I modeled this Super Mario star and back-shell to hold in place a 3.5mm stereo plug/jack audio extension cable so I could route the headphones jack to the front panel of my custom arcade cabinet. It…
To wszystkie aktualnie dostępne wyniki.
