Liczymy pasujące modele…
This Hat is inspired by RJ Design's impossible cone. The tip (inner part) has a 0.5 mm gap in X and Y directions to make it run smoothly. However, the bottom part has overhangs that demand your printer be well calibrated. You could use…
It is meant to be easy to print as two separate pieces, with no difficult overhangs. Tolerance between parts it around 0.5 mm, so it should run smoothly. I used a 0.6 nozzle with 0.7 mm wide walls and a 0.3 mm layer height. I appreciate…
This is one of my first designs. I wanted to create a joint holder that would be easy and quick to print, and use little material, so I chose a solid version to print in vase mode. Size is 90 mm tall and 15 mm opening, then narrowing down…
I designed this simple toothed clamp (or holder) for broomsticks and other similar shapes. It is meant to be printed in TPU or other flexible materials. The "teeth" have an inner diameter of 22 mm. It can hold sticks up to about 28 mm in…
I couldn't find any suitable stands for this giant laptop, so I created my own. No AI used whatsoever. This laptop is approximately 40x28 cm and quite heavy. It's an easy print, but the tolerances are tight. If your printer is not…
I've been using the Smartsift litter box for a few years now, and the side latches broke. I designed replacement parts with slightly reinforced hooks, that work well even in PLA. My suggestion: Print on the flat side, using support for…
To wszystkie aktualnie dostępne wyniki.
