Liczymy pasujące modele…
A 25mm square single layer test print for checking your 1st layer calibration. For minimum clean up there is no brim, and a small handle to pull the print off the bed without removing the sheet. g-code for both PLA and PETG Two versions…
As there was no Mini sheet holder that quite met my requirements, I remixed an existing design.
Anyone with Thule WingBar will know how important the little filler pieces are to stop whistling. So when I needed to replace the lower cover strips on second hand Thule WingBars. Rather than purchasing replacements decided to 3D print…
Tired of tangled Cam straps? This is a spool for keeping Cam straps tidy between uses. Designed for 25mm Cam straps upto 4.5 metres in length. Print instructions I recommend PETG or other more flexible filament than PLA to allow the two…
I wanted to raise the height of my LACK enclosure by 10mm to allow air flow under the sides and give the Bowden tube more space before hitting the enclosure.
I wanted to be alerted when my prints had finished on my Prusa MINI 3d printer. What better way then a pager; OK a smart phone App! The PrusaConnect Local web page is great for tracking the status of prints, but does not alert you when…
This is an Arduino based OLED thermometer for IKEA LACK enclosures. This project uses an Arduino Uno as it has an on-board voltage regulator that would accept the same 12 volt supply that I am using for the LED lighting. Other models such…
To wszystkie aktualnie dostępne wyniki.
