Liczymy pasujące modele…
Sadly it uses a lot of support material to print .2-.3 layer high recommended can take up to a week to print there are no side panel stl files yet, if I see there is interest in the car and enough people ask for the side panels I will add…
If you would like a kit made that you could buy with all the parts preassembled with instructions comment on this model or use the messaging service in Printables Note: Still work in progress as of this date. If you want different magnet…
Disclaimer: My A1 Mini nozzle wiper is missing “teeth” because an earlier design didn't hold the probed pads on good enough. You will need to have your printer rooted to be sure it will not interfere with the probed area. Needed…
General information This is a 1/10th scale rc crawler that I designed. This is a rear steer rc car based off of a Willy's jeep using axial scx10 II parts. The wheelbase is much shorter than the average rc car, it is a Willy's jeep after…
does not need any supports, only downside is the tow pins that go into the back of the box that hold the lid on need to be scaled to different sizes depending on the printer accuracy, I suggest starting with 90% size
Sadly it needs some support, some 3D printers can get away with no support but good cooling is required This piece goes into the counsel in the roof to be able to add more places for switches Requires cutting the console, and the…
Needs little support very fast CO2 car can beat almost any other car made, less walls and infill the faster it will go.
Uses a little support on the underside of the main clamp piece where the paper towel clamp slides in very snuggly (mallet suggested) print with almost any material other than a squishy and very brittle material choose if you want the…
If your battery tray is a chevy and its a single bolt design it should fit. I would suggest full infill and a high temp filament such as ABS
Wanna build your own version of a voron switchwire but already have cable chains and don't want to print new ones than just print this piece and put the one heat set insert into it. It allows the use of standard ender 3 style cable chains…
scale to size as needed (pics use an M5 T nut) if there is a size you want or something that you would like me to add just comment
make your own voron switchwire but without the expanse of linear rails, does rewire heat set inserts (6) so make sure you have those.
Durable spools to reload with your wire.
A clamp to hold the Z carriage the ones with the ribs will pop into the frame and hold the Z carriage up for easier use The thin clamps are good for things like the belted Z
An adjustable clamp to go on any table side to hold common use 3D printer tools No support material required
Print in ABS or PETG for best performance if printed in PLA higher infill is recommended
Needs a 4010 axial fan. Adds more electronics cooling
To wszystkie aktualnie dostępne wyniki.
